Perfect companion to DCC installation and operation, the decoder tester works with ANY DCC decoder. Test for motor forward and reverse, functions 0F, 0R, 1, and 2.
Provides short circuit protection for up to three power districts. Can be used with any DCC command system.
Detects DCC current being drawn in a block. Connects to AIU01 or most commercial signal systems.
The Auxiliary Input Unit provides connection of block occupancy detectors, switch position relays, etc. for purposes of signaling and/or computer control of your layout. Simply plugs in to the Cab Bus.
Operates 4 signal heads. Can be used with Cab control, Computer control or Interlocking and CTC.
Operates two signal heads. Can be used as a "stand alone" signal system. Use with Cab control, computer control, CTC or DC systems.
Provides short circuit protection for one power district. Can be used with any DCC command system.
Use the NCE Packet Analyzer and your computer to view DCC packets being sent by any DCC system. Selectively filter out idle, reset, accessory, function and/or speed packets. Information can be displayed in hexidecimal or our special "verbose" mode that makes it easy to decipher track activity. Requires PC, Mac or Linux computer with terminal program and 9 pin serial cable. Can also be used to monitor NCE Cab Bus activity.
Add this USB computer interface for computer programming and/or operation of your Power Cab equipped layout. Requires USB cable, computer and railroad computer program such as JMRI Decoder Pro and Panel Pro. Can be used with the PH Pro and PH10 systems. HOWEVER, with the PH systems you can only RUN or OPERATE railroads with it. You can not use the USB Interface to Program decoders.
